Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
Keyless Entry Transmitter Battery: Service and Repair
TRANSMITTER BATTERY
REMOVAL
1. REMOVE TRANSMITTER COVER
NOTE: Great caution should be taken for handling each component as they are precision electronic components.
a. Using a screwdriver, remove the cover.
NOTE: Do not pry out the cover forcibly.
HINT: Push the cover with a finger as shown in the illustration, so that there becomes clearance, then pry out the cover from that clearance.
b. Remove the transmitter.
2. REMOVE TRANSMITTER BATTERY
NOTE:
-
Do not push the terminals with a finger.
-
If prying up the battery (lithium battery) forcibly to remove, the terminals are deformed.
INSTALLATION
1. INSTALL TRANSMITTER BATTERY
a. Install a battery (lithium battery).
NOTE: Face the battery upward. Take care not to deform the terminals.
2. INSTALL TRANSMITTER COVER
a. Check that the rubber cover is not distorted or slipped off, and install the cover.