Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
Wheel Speed Sensor: Service and Repair
Rear Speed Sensor
Rear Speed Sensor
REMOVAL
1. DISCONNECT REAR SPEED SENSOR CONNECTOR
2. REMOVE REAR SPEED SENSOR LH
a. Remove the 6 resin clips holding the sensor wire harness.
b. Remove the bolt and speed sensor from the axle carrier.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check speed sensor signal.