Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
mark of the crankshaft timing pulley.
30. REMOVE NO. 1 IDLER PULLEY
a) Using a 10 mm hexagon wrench, remove the bolt, No. 1 idler pulley and plate washer.
b) Remove the bolt and No. 2 idler pulley.
31. REMOVE NO. 2 IDLER PULLEY
a) Using a 10 mm hexagon wrench, remove the bolt, No. 2 idler pulley and plate washer.
b) Remove the bolt and No. 2 idler pulley.
32. REMOVE CRANKSHAFT TIMING PULLEY
a) Using SST, remove the timing pulley.
SST 09950-50013 (09951-05010, 09952-05010, 09953-05010, 09953-05020, 09954-05011)
NOTICE: Do not turn the timing pulley.
INSTALLATION
1. INSTALL CRANKSHAFT TIMING PULLEY
a) Align the timing pulley set key with the key groove of the pulley
b) Using SST and a hammer, tap in the timing pulley, facing the flange side inward.
SST 09223-46011
2. INSTALL NO. 2 IDLER PULLEY
3. INSTALL NO. 1 IDLER PULLEY