Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
/Page-1273002.png)
a. Remove the 3 screws and heater unit.
INSTALLATION
Installation is in the reverse order of removal.
Disassembly and Reassembly
DISASSEMBLY
1. REMOVE HEATER RADIATOR
a. Remove the 3 screws and 3 clamps.
b. Pull out the heater radiator.
c. Remove the 2 screws and 2 clips, then disconnect the heater radiator pipes.
2. REMOVE AIR DUCT
a. Remove the 3 screws and duct.
3. REMOVE MODE DAMPER SERVO
a. Remove the 3 screws and servomotor.
4. REMOVE AIR MIX DAMPER SERVO
a. Remove the 3 screws and servomotor.
5. REMOVE AIR HOSE
REASSEMBLY
Reassembly is in the reverse order of disassembly.
