Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
Impact Sensor: Service and Repair
Front Airbag Sensor
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE FRONT AIRBAG SENSOR LH
a. Disconnect the connector from the front airbag sensor LH.
NOTE: Disconnect the connector with the front airbag sensor LH installed.
b. Remove the 2 nuts and the front airbag sensor LH.
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. INSTALL FRONT AIRBAG SENSOR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
c. Install the front airbag sensor LH with the 2 nuts.
Torque: 17.5 N.m (179 kgf.cm, 13 ft.lbf)
NOTE: