Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
Evaporator Temperature Sensor / Switch: Service and Repair
THERMISTOR ASSEMBLY (for Rear Air Conditioning System)
REMOVAL
1. REMOVE SIDE HEATER LOWER COVER
2. REMOVE THERMISTOR ASSEMBLY
a. Disconnect the connector and connector clamp.
b. Using a screwdriver, pull out the sensor.
HINT: Tape the screwdriver tip before use.
c. Release the 2 claws and remove the sensor from the bracket plate.
INSTALLATION
1. INSTALL THERMISTOR ASSEMBLY
2. INSTALL SIDE HEATER LOWER COVER