Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
/Page-1162001.png)
Stabilizer Bar: Service and Repair
Front Stabilizer Bar
FRONT STABILIZER BAR
Components
REMOVAL
1. REMOVE FRONT STABILIZER LINK ASSEMBLY LH
a. Remove the nut and disconnect the stabilizer bar links from the lower suspension arm.
HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
2. REMOVE FRONT STABILIZER LINK ASSEMBLY RH
a. Remove the nut and disconnect the stabilizer bar links from the lower suspension arm.
HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
