Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
Air Spring: Service and Repair
REAR PNEUMATIC CYLINDER
Components
REMOVAL
NOTICE:
-
Do not extend the pneumatic cylinder by itself. If the cylinder is fully extended, it cannot be reused.
-
Do not replenish the pneumatic cylinder by itself with air.
-
Do not remove the pneumatic cylinder with air in it.
-
If reusing the pneumatic cylinder, replace the 2 O-rings, plate and connector No. 2 with new ones.
-
When installing the pneumatic cylinder, keep the cylinder length 260 mm (10.236 inch) or less.
1. BLEED AIR
HINT: Disconnect the one touch air connector of the height control valve and bleed the air.
2. REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY
a. Jack up the vehicle and support the frame with safety stands.