Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
/Page-1172002.png)
2. REMOVE FRONT SHOCK ABSORBER ASSEMBLY
a. Remove the shock absorber lower side set nut and washer.
NOTICE: Do not remove the bolt.
b. Pry down the lower suspension arm to remove the bolt and disconnect the shock absorber.
3. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING
a. Remove the 3 nuts and shock absorber with the coil spring.
DISASSEMBLY
1. REMOVE FRONT SUSPENSION SUPPORT AND FRONT COIL SPRING
a. Using a spring compressor, compress the coil spring.
NOTICE:
^
Use a spring compressor with which compressive force of 12,740 N (1,300 kgf, 2,860 lbs) or more can be applied.
^
Make sure that the suspension support is free from the coil spring.
^
Do not compress the coil spring more than necessary.
^
Do not place yourself over the top of the shock absorber.
b. Remove the suspension support center nut.
c. Remove the 2 retainers, cushion, suspension support and coil spring.
INSPECTION
