Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
/Page-890004.png)
a. Using a snap ring expander, remove the snap ring.
4. REMOVE REAR AXLE SHAFT
a. Attach the washers and nut to the serration bolts, then torque the nuts to install the serration bolts to the backing plate
b. Remove the 4 nuts from the serration bolts.
c. Position SST on the backing plate with the 4 nuts.
SST 09521-25011, 09521-25021
d. Using a press, remove the rear axle shaft, spring washer and bearing retainer from the backing plate.
e. Remove the SST
SST 09521-25011, 09521-25021
5. REMOVE BRAKE DRUM OIL DEFLECTOR
a. Using a brass bar and hammer, remove the 6 hub bolts, oil deflector and gasket.
6. REMOVE REAR AXLE BEARING
a. Attach the 4 nuts to the serration bolts and remove the serration bolts from the backing plate using a hammer.
NOTICE: Do not reuse the nuts previously removed from the vehicle.
INSPECTION
