Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
b. Using SST and a press, remove the bearing from the steering knuckle.
SST 09950-60020 (09951-00810), 09950-70010 (09951-07150)
REASSEMBLY
1. INSTALL FRONT AXLE HUB BEARING
a. Using SST and a press, install a new bearing to the steering knuckle.
SST 09527-17011, 09950-60020 (09951-00910)
b. Using snap ring pliers, install a new snap ring.
2. INSTALL FRONT AXLE HUB OIL SEAL
a. Using SST and a plastic hammer, install a new oil seal (outside).
SST 09223-15030, 09527-17011
b. Coat MP grease to the oil seal lip.
3. INSTALL FRONT AXLE HUB
a. Install the dust cover to the steering knuckle with the 4 bolts.
Torque: 18 Nm (185 kgf-cm, 13 ft. lbs.)
b. Using SST and a press, install the axle hub to the steering knuckle.
SST 09649-17010
4. INSTALL SPEED SENSOR ROTOR