Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
12. REMOVE NO.2 REAR WINDOW SIDE GARNISH ASSEMBLY
a. Remove the 2 clips and No. 2 rear window side garnish.
13. REMOVE REAR SEAT OUTER BELT SHOULDER ANCHOR
a. Using a screwdriver, remove the anchor cap.
HINT: Tape the screwdriver tip before use.
b. Remove the rear No. 1 seat outer belt shoulder anchor.
14. REMOVE REAR WINDOW SIDE GARNISH ASSEMBLY
a. Remove the rear window side garnish.
15. REMOVE QUARTER WINDOW GLASS
a. with Glass antenna:
Disconnect the connectors from the glass antenna terminals.
b. Push a piano wire through from the interior.
c. Tie both wire ends to wooden blocks or similar objects.
HINT: Apply protective tape to the outer surface to keep the surface from being scratched.
NOTE: When separating the glass, take care not to damage the paint and interior.
d. Cut the adhesive by pulling the piano wire around it.
HINT: Cut the adhesive areas as shown in the illustration, leaving the adhesive where the clips are.