Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
b. Engage the connector and clamp.
c. Connect the connector.
3. INSTALL BACK DOOR POWER WINDOW REGULATOR ASSEMBLY
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
4. INSTALL BACK DOOR GLASS
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
5. INSTALL BACK DOOR SERVICE HOLE COVER LH
6. INSTALL BACK DOOR SERVICE HOLE COVER RH
7. INSTALL BACK DOOR TRIM BOARD
8. INSTALL BACK DOOR SIDE GARNISH
9. INSTALL BACK DOOR CENTER GARNISH
10. INSTALL BACK DOOR PULL STRAP
11. INSTALL WIPER STEP LINER
12. INSTALL REAR WIPER ARM ASSEMBLY
a. Install the rear wiper motor grommet as shown in the illustration.
b. Operate the wiper once and turn the wiper switch OFF.
c. Install the wiper arm as shown in the illustration, then torque the nut.
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
d. Set the wiper arm to rise-up position as shown in the illustration.
e. Close the cover.