Sequoia 4WD V8-5.7L (3UR-FE) (2009)
AUDIO / VIDEO: REAR DOOR SPEAKER: REMOVAL
REMOVAL
HINT:
-
Use the same procedure for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. REMOVE REAR DOOR FRAME GARNISH RH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG RH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
3. REMOVE REAR UPPER DOOR ARMREST BASE PANEL RH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY RH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
5. REMOVE REAR NO. 1 SPEAKER ASSEMBLY
(a) Disconnect the speaker connector.
(b) Remove the 3 screws.
(c) Disengage the 2 claws and remove the speaker.
NOTE: Do not touch the cone part of the speaker.
6. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 14 Speakers)
(a) Disengage the 3 claws and remove the speaker.
Installation
AUDIO / VIDEO: REAR DOOR SPEAKER: INSTALLATION
INSTALLATION
HINT:
-
Use the same procedure for the RH side and LH side.