Sequoia 4WD V8-5.7L (3UR-FE) (2009)
connector C.
3. CHECK FOR SHORT CIRCUIT
(a) If the wire harness is ground shorted (Fig. 5), locate the section by conducting a resistance check with the body ground (below).
(b) Check the resistance with the body ground.
(1) Disconnect connectors A and C and measure the resistance.
Standard resistance (Fig. 6):
HINT:
Measure the resistance while lightly shaking the wire harness vertically and horizontally.
If your results match the examples above, a short circuit exists between terminal 1 of connector A and terminal 1 of connector C.
(2) Disconnect connector B and measure the resistance.
Standard resistance (Fig. 7):
If the results match the examples above, a short circuit exists between terminal 1 of connector B2 and terminal 1 of connector C.
4. CHECK AND REPLACE ECU
NOTICE:
-
The connector should not be disconnected from the ECU. Perform the inspection from the backside of the connector on the wire harness
side.
-
When no measuring condition is specified, perform the inspection with the engine stopped and the ignition switch ON.
-
Check that the connectors are fully seated. Check for loose, corroded or broken wires.