Sequoia 4WD V8-5.7L (3UR-FE) (2009)
8. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Power Seat)
(a) Remove the rear No. 2 seat assembly LH See: Seats/Service and Repair/Rear No. 2 Seat Assembly (for Power Seat Type LH Side)/Removal.
9. REMOVE REAR SEAT CUSHION HINGE LOWER COVER LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
10. REMOVE REAR FLOOR STEP NO. 1 COVER See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
11. REMOVE REAR FLOOR STEP NO. 2 COVER See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
12. REMOVE REAR DOOR SCUFF PLATE LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
13. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
14. REMOVE ROPE HOOK ASSEMBLY See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
15. REMOVE REAR FLOOR MAT SUPPORT PLATE See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
16. REMOVE QUARTER TRIM PANEL ASSEMBLY LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
17. REMOVE QUARTER TRIM PANEL ASSEMBLY LH (for Power Seat) See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
18. REMOVE REAR WINDOW NO. 2 SIDE GARNISH ASSEMBLY LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
19. REMOVE BACK DOOR CONTROL SWITCH
(a) Remove the screw.
(b) Using a screwdriver with its tip wrapped in protective tape, engage the claw and remove the No. 3 side trim base with back door control switch
from the rear window side garnish assembly LH.
(c) Using a screwdriver with its tip wrapped in protective tape, engage the 4 claws and remove the back door control switch from the No. 3 side
trim base.
Installation
DOOR / HATCH: POWER BACK DOOR CONTROL SWITCH (for Luggage Compartment): INSTALLATION
INSTALLATION
1. INSTALL BACK DOOR CONTROL SWITCH
(a) Engage the 4 claws and install the back door control switch onto the No. 3 side trim base.