Sequoia 4WD V8-5.7L (3UR-FE) (2009)
/Page-2656004.png)
(2) Using a piece of cloth, rub the double-sided adhesive tape off the back door panel while it is hot from the infrared light.
NOTE: Installing the No. 4 back door name plate while any double-sided tape remains on the luggage compartment door panel may cause
adhesion failure. Therefore, completely remove the double-sided tape.
(3) Using a non-residue solvent, clean the attachment surface.
(b) Install a new No. 4 back door name plate as shown in the illustration.
Installation Position:
NOTE: Install the No. 4 back door name plate in an environment where the ambient temperature is over 20°C (68°F). If it is below 20°C (68°
F), using an infrared light, heat the back door panel and the No. 3 back door name plate up to 20 to 30°C (68 to 86°F) and install the No. 4
back door name plate.
4. INSTALL SYMBOL EMBLEM
(a) Clean the attachment surface.
(1) Using an infrared light, heat the double-sided adhesive tape remaining on the back door panel.
HINT: Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.
(2) Using a piece of cloth, rub the remaining double-sided adhesive tape off the back door panel while it is hot from the infrared light.
NOTE: Installing the symbol emblem with any double-sided tape remaining on the back door panel may cause adhesion failure. Therefore,
completely remove the double-sided tape.
(3) Using a non-residue solvent, clean the attachment surface.
(b) Insert the 2 pins into the back door panel and install the symbol emblem.
