Sequoia 4WD V8-5.7L (3UR-FE) (2009)
(a) Disconnect the connector.
(b) Remove the 3 screws and front power seat switch.
Installation
SEAT: POWER SEAT SWITCH (for Front Seat): INSTALLATION
INSTALLATION
HINT:
-
Use the same procedure for the LH side and RH side.
-
The procedure listed below is for the LH side.
1. INSTALL FRONT POWER SEAT SWITCH LH (w/o Memory)
(a) Install the front power seat switch with the 3 screws.
(b) Connect the connector.
2. INSTALL LEG SUPPORT ADJUSTMENT SWITCH (w/ Leg Support Adjustment Switch)
(a) Connect the connector.
(b) Install the leg support adjustment switch with the 2 screws.
(c) Engage the 2 wire harness clamps.
3. INSTALL FRONT POWER SEAT LUMBAR SWITCH (for Power Seat)
(a) Install the front power seat lumbar switch with the 2 screws.
(b) Connect the connector.
4. INSTALL FRONT POWER SEAT LUMBAR SWITCH (for Manual Seat)