Sequoia 4WD V8-5.7L (3UR-FE) (2009)
Yaw Rate Sensor: Service and Repair
Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND DECELERATION SENSOR: REMOVAL
REMOVAL
1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front Console
Box/Removal
2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front
Console Box/Removal
3. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Front Console Box/Removal
4. REMOVE REAR CONSOLE BOX POCKET See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front Console
Box/Removal
5. REMOVE CONSOLE BOX CARPET See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front Console Box/Removal
6. REMOVE REAR CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front Console
Box/Removal
7. REMOVE YAW RATE SENSOR
(a) Remove the 2 nuts (labeled A) and sensor.
(b) Disconnect the sensor connector (labeled B), and then detach the clamp (labeled C) from the sensor bracket.