Sequoia 4WD V8-5.7L (3UR-FE) (2009)
Cruise Control Switch: Service and Repair
Removal
CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE: When disconnecting the cable some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
2. REMOVE LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Removal
3. REMOVE LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Removal
4. REMOVE STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Removal
5. REMOVE CRUISE CONTROL MAIN SWITCH
(a) Disconnect the connector.
(b) Remove the 2 screws.
(c) Remove the switch, as shown in the illustration.