Sequoia 4WD V8-5.7L (3UR-FE) (2009)
Tire Pressure Module: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: INSTALLATION
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ECU
(a) Install the tire pressure warning ECU with the 2 nuts.
Torque: 7.5 Nm (76 kgf-cm, 66 in-lbf)
(b) Connect the tire pressure warning ECU connector.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH See: Dashboard / Instrument Panel/Service and
Repair/Installation
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Dashboard / Instrument Panel/Service and
Repair/Installation
4. INSTALL INSTRUMENT SIDE PANEL RH See: Dashboard / Instrument Panel/Service and Repair/Installation
5. INSTALL COWL SIDE TRIM BOARD RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
6. INSTALL FRONT DOOR SCUFF PLATE RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
7. REGISTRATION TRANSMITTER ID See: Testing and Inspection/Programming and Relearning/Registration
8. INSPECT TIRE PRESSURE WARNING SYSTEM See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode
Procedure
9. INITIALIZE SYSTEM See: Testing and Inspection/Programming and Relearning/Initialization