Sequoia 4WD V8-5.7L (3UR-FE) (2009)
Brake Light Switch: Service and Repair
Installation
LIGHTING (EXT): STOP LIGHT SWITCH: INSTALLATION
INSTALLATION
1. INSTALL STOP LIGHT SWITCH ASSEMBLY
(a) Install the stop light switch into the adjuster until it slightly touches the brake pedal.
NOTE: Do not depress the brake pedal.
(1) Make a quarter turn clockwise to install the stop light switch.
NOTE: Do not depress the brake pedal.
HINT: Do not tighten the stop light switch more than the torque specification.
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)
(b) Check the stop light switch clearance.
Stop light switch clearance:
0.5 to 2.6 mm (0.020 to 0.102 in.)
(c) Connect the stop light switch connector to the stop light switch.