Sequoia 4WD V8-5.7L (3UR-FE) (2009)
(c) Tighten the nut.
Torque: 250 Nm (2549 kgf-cm, 185 ft-lbf)
5. INSPECT TOE-IN
Standard toe-in:
B - A 0 +/- 2 mm (0 +/- 0.08 in.)
If the toe-in is not within the specified range, inspect the suspension parts and replace if necessary.
6. ADJUST TOE-IN
(a) Loosen the toe adjust cam bolt.
(b) Rotate the toe adjust plate on the vehicle side of lower arm No. 2 to adjust toe-in.
Standard toe-in:
0 +/- 1 mm (0 +/- 0.04 in.)
(c) Tighten the bolt.
Torque: 120 Nm (1224 kgf-cm, 89 ft-lbf)
7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ VSC)
NOTE: Disconnect the negative battery terminal for more than 2 seconds.
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ VSC)
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
9. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION (w/ VSC) See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Testing and Inspection/Programming and Relearning
10. CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION (w/ VSC) See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/C Code Charts/C1290