Sequoia 4WD V8-5.7L (3UR-FE) (2009)
/Page-1094119.png)
(b) w/o AVS
(1) Reconnect the cable to the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
(2) Disconnect the O19 suspension control ECU connector.
(3) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(4) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE SUSPENSION CONTROL ECU
4WD Control ECU Communication Stop Mode
NETWORKING: CAN COMMUNICATION SYSTEM: 4WD Control ECU Communication Stop Mode
4WD Control ECU Communication Stop Mode
DESCRIPTION
HINT: w/ 4WD
WIRING DIAGRAM
