Sequoia 4WD V8-5.7L (3UR-FE) (2009)
1. INSTALL AIRBAG SENSOR ASSEMBLY
(a) Confirm that the ignition switch is turned off.
(b) Confirm that the negative battery terminal is disconnected.
CAUTION:
-
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag
sensor will cause the airbag to deploy.
-
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Install the airbag sensor with the 3 bolts.
Torque: 18 Nm (184 kgf-cm, 13 ft-lbf)
NOTICE:
-
Do not use an airbag sensor that has been dropped.
-
Do not subject the airbag sensor to any impact or force.
-
Confirm that the carpet does not interfere with the installation plane.
(d) Confirm that there is no looseness by shaking the front airbag sensor.
(e) Connect the connector holder to lock the lever.
NOTE: Confirm that the lever is locked.
(f) Confirm that the drip-proof sheet has not been removed and does not cut into the connectors.
2. INSTALL FRONT CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front Console Box/Installation
3. INSTALL REAR CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front Console
Box/Installation
4. INSTALL CONSOLE BOX CARPET See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front Console Box/Installation
5. INSTALL REAR CONSOLE BOX POCKET See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front Console
Box/Installation
6. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Front Console Box/Installation
7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front
Console Box/Installation
8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front Console
Box/Installation
9. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
10. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release