Sequoia 4WD V8-5.7L (3UR-FE) (2009)
HINT: Use the same procedure as for the LH side.
5. REMOVE FRONT BUMPER COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
6. REMOVE NO. 1 ULTRASONIC SENSOR
(a) Disconnect the connector.
(b) While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.
HINT: The type of the claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting to removing the
sensor.
7. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER
(a) Disengage the 2 claws and remove the ultrasonic sensor retainer from the front bumper.
Installation
PARK ASSIST / MONITORING: ULTRASONIC SENSOR (for Front Side): INSTALLATION
INSTALLATION
1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
(a) Install the ultrasonic sensor retainer to the front bumper.
NOTE: Do not damage the bumper with the snap when installing the retainer.
HINT: When installing the retainer, align the keyhole and snap as shown in the illustration.
2. INSTALL NO. 1 ULTRASONIC SENSOR