Sequoia 4WD V8-5.7L (3UR-FE) (2009)
LIGHTING (INT): FRONT DOOR COURTESY SWITCH: REMOVAL
REMOVAL
HINT:
-
Use the same procedure for both the RH and LH sides.
-
The procedure described below is for the LH side.
1. REMOVE FRONT DOOR SCUFF PLATE
HINT: Use the same procedure as for the RH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal.
2. REMOVE REAR DOOR SCUFF PLATE
HINT: Use the same procedure as for the RH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal.
3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP
HINT: Use the same procedure as for the RH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal.
4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP
HINT: Use the same procedure as for the RH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal.
5. REMOVE LOWER CENTER PILLAR GARNISH
HINT: Use the same procedure as for the RH side See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer
Belt Assembly/Removal.
6. REMOVE COURTESY LIGHT SWITCH
(a) Using "TORX" socket wrench T30, remove the screw.
(b) Disconnect the connector and remove the courtesy light switch.
Installation
LIGHTING (INT): FRONT DOOR COURTESY SWITCH: INSTALLATION
INSTALLATION
1. INSTALL COURTESY LIGHT SWITCH
(a) Connect the connector.
(b) Using "TORX" socket wrench T30, install the courtesy light switch with the screw.
Torque: 3.7 Nm (38 kgf-cm, 33 in-lbf)
2. INSTALL LOWER CENTER PILLAR GARNISH
HINT: Use the same procedure as for the RH side See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer
Belt Assembly/Installation.
3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
HINT: Use the same procedure as for the RH side See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer
Belt Assembly/Installation.