Sequoia 4WD V8-5.7L (3UR-FE) (2009)
WINDOW / GLASS: REAR POWER WINDOW SWITCH: REMOVAL
REMOVAL
HINT:
-
Use the same procedure for both the RH and LH sides.
-
The procedure described below is for the LH side.
1. REMOVE REAR DOOR ARMREST BASE UPPER PANEL See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the rear power window regulator switch.
Installation
WINDOW / GLASS: REAR POWER WINDOW SWITCH: INSTALLATION
INSTALLATION
1. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a) Engage the 2 claws and install the rear power window regulator switch.
2. INSTALL REAR DOOR ARMREST BASE UPPER PANEL See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Reassembly