Sequoia 4WD V8-5.7L (3UR-FE) (2009)
/Page-1747002.png)
(g) Align the groove with the neutral basic line.
(h) Hold the switch in the position described above and tighten the bolt.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)
(i) Using a screwdriver, bend the tabs of the lock washer.
(j) Install the transmission control shaft lever RH with the spring washer and nut.
Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)
(k) Connect the switch connector.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Connect the cable with the nut.
Torque: 14 Nm (143 kgf-cm, 10 ft-lbf)
NOTE: When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the outside of the vehicle.
3. INSPECT SHIFT LEVER POSITION See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Testing and
Inspection/Initial Inspection and Diagnostic Overview
4. ADJUST SHIFT LEVER POSITION See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Adjustments
5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY See: Testing and Inspection/Initial Inspection and Diagnostic Overview
