Sequoia 4WD V8-5.7L (3UR-FE) (2009)
Acceleration Sensor: Testing and Inspection
SUSPENSION CONTROL: FRONT ACCELERATION SENSOR: INSPECTION
INSPECTION
1. INSPECT ACCELERATION SENSOR ASSEMBLY
(a) Inspect the acceleration sensor LH.
(b) Connect 3 dry cell batteries of 1.5 V in series.
(c) Connect the positive (+) end of the batteries to terminal 3 (SGV) of the acceleration sensor and the negative (-) end of the batteries to terminal
2 (SGND). Then measure the voltage between terminal 1 (SGRR) and terminal 2 (SGND).
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NOTE: Do not apply a voltage of more than 6 V.
HINT: When the acceleration sensor is tilted, it may output a different value.
(e) Inspect the acceleration sensor RH.