Sequoia 4WD V8-5.7L (3UR-FE) (2009)
/Page-2100002.png)
(f) Connect 3 dry cell batteries of 1.5 V in series.
(g) Connect the positive (+) end of the batteries to terminal 3 (SHB) of the acceleration sensor and the negative (-) end of the batteries to terminal
2 (SHG). Then measure the voltage between terminal 1 (SGFL) and terminal 2 (SHG).
(h) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NOTE: Do not apply a voltage of more than 6 V.
HINT: When the acceleration sensor is tilted, it may output a different value.
