Sequoia 4WD V8-5.7L (3UR-FE) (2009)
/Page-1468010.png)
HINT: Use the same procedure as the LH side.
5. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
(a) Remove the bolt and rear differential carrier assembly.
(b) Support the rear differential with a jack.
(c) Slowly lower the jack, and remove the rear differential carrier.
Installation
AXLE AND DIFFERENTIAL: REAR DIFFERENTIAL CARRIER ASSEMBLY: INSTALLATION
INSTALLATION
1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
(a) Using a jack, slowly raise the rear differential carrier assembly to its installation position.
(b) Temporarily install the 6 bolts.
(c) Tighten the 4 bolts in order, from A to D.
Torque: 120 Nm (1224 kgf-cm, 89 ft-lbf)
Using hexagon wrench, tighten the 2 bolts order, E to F.
Torque: 200 Nm (2039 kgf-cm, 148 ft-lbf)
2. INSTALL REAR DRIVE SHAFT ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and
Replacement/Rear Drive Shaft Assembly/Installation
3. INSTALL REAR DRIVE SHAFT ASSEMBLY RH
HINT: Use the same procedure as the LH side.
4. INSTALL PROPELLER SHAFT ASSEMBLY (for 4WD) See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and
Repair/Removal and Replacement/Propeller Shaft Assembly/Installation
5. INSTALL PROPELLER SHAFT ASSEMBLY (for 2WD) See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and
Repair/Removal and Replacement/Propeller Shaft Assembly/Installation
6. ADD DIFFERENTIAL OIL See: Fluid - Differential/Service and Repair
7. INSPECT FOR OIL LEAK
