Sequoia 4WD V8-5.7L (3UR-FE) (2009)
/Page-1469003.png)
(a) Using SST, remove the oil seal.
SST: 09308-10010
8. REMOVE FRONT DIFFERENTIAL DRIVE PINION OIL SLINGER
9. REMOVE FRONT DIFFERENTIAL CROSS SHAFT BEARING RETAINER
(a) Remove the bolts B and front differential front support assembly LH.
(b) Remove the bolts A.
(c) Using a plastic-faced hammer, tap out the bearing retainer.
10. REMOVE DIFFERENTIAL CASE ASSEMBLY
(a) Remove the differential case from the differential carrier.
11. REMOVE DIFFERENTIAL DRIVE PINION
(a) Set the differential carrier to an overhaul stand as shown in the illustration.
(b) Using a press, press out the drive pinion.
NOTE: Do not drop the drive pinion.
12. REMOVE FRONT DRIVE PINION FRONT RADIAL BALL BEARING
(a) Remove the bearing (inner race) from the differential carrier.
13. REMOVE FRONT DIFFERENTIAL BREATHER PLUG OIL DEFLECTOR
