Sequoia 4WD V8-5.7L (3UR-FE) (2009)
/Page-1491004.png)
NOTE: Keep the groove where you are fitting the boot free of grease.
4. INSTALL FRONT AXLE NO. 2 OUTBOARD JOINT BOOT SETTING CLAMP
(a) Install the No. 2 outboard joint boot setting clamp onto the outboard joint boot.
(b) Using SST, pinch the clamp.
SST: 09521-24010
NOTE: Do not overtighten SST.
5. INSTALL FRONT AXLE NO. 1 OUTBOARD JOINT BOOT SETTING CLAMP
(a) Install the No. 1 outboard joint boot setting clamp onto the outboard joint boot.
(b) Using SST, pinch the clamp.
SST: 09521-24010
NOTE: Do not overtighten SST.
6. INSPECT AND ADJUST FRONT AXLE OUTBOARD JOINT BOOT SETTING CLAMP
(a) Using SST, inspect and adjust the clearance of the boot setting clamps.
SST: 09240-00020
Standard Clearance:
7. TEMPORARILY INSTALL FRONT DRIVE SHAFT INBOARD JOINT BOOT
(a) Wrap the spline of the outboard joint shaft with vinyl tape to prevent the boots from being damaged.
(b) Temporarily install the new inboard joint boot to the outboard joint shaft.
8. INSTALL FRONT DRIVE SHAFT INBOARD JOINT SHAFT ASSEMBLY
