Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
6. REMOVE SIDE AND CURTAIN SHIELD AIRBAG SENSOR ASSEMBLY
a. Disconnect the connector.
NOTE: Disconnect the connector with the sensor assembly installed.
b. Remove the 3 bolts and side and curtain shield airbag sensor assembly.
INSTALLATION
NOTE:
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new ones.
-
Never reuse the side and curtain shield airbag sensor assembly involved in a collision when the airbag has deployed.
-
Never repair a sensor in order to reuse it.
1. INSTALL SIDE AND CURTAIN SHIELD AIRBAG SENSOR
a. Install the side and curtain shield airbag assembly with the 3 bolts.
Torque: 20 N.m (205 kg.cm, 15 ft.lb)
b. Connect the connector.
NOTE:
-
Connection of the connector is done after the sensor assembly has been installed.
-
Make sure the sensor assembly is installed with the specified torque.
-
If the sensor assembly has been dropped or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other
parts.
-
After installation, shake the sensor assembly to check that there is no looseness.
2. INSTALL RETRACTOR OF FRONT SEAT OUTER BELT
Torque: 44 N.m (450 kg.cm, 32 in.lb)
3. INSTALL CENTER PILLAR LOWER GARNISH
4. INSTALL FRONT SEAT OUTER BELT FLOOR ANCHOR
Torque: 44 N.m (450 kg.cm, 32 in.lb)
5. INSTALL FRONT DOOR SCUFF PLATE