Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Transmission Temperature Sensor/Switch: Service and Repair
ON-VEHICLE REPAIR
1. DISCONNECT ATF TEMPERATURE SENSOR CONNECTOR
2. REMOVE ATF TEMPERATURE SENSOR
a. Remove the ATF temperature sensor.
b. Remove the O-ring from the ATF temperature sensor.
3. INSTALL ATF TEMPERATURE SENSOR
a. Coat a new O-ring with ATF and install it to the ATF temperature sensor.
b. Install the ATF temperature sensor.
Torque: 15 Nm (150 kgf-cm, 11 ft. lbs.)
4. CONNECT ATF TEMPERATURE SENSOR CONNECTOR
NOTICE: Be careful not to twist the wire harness.
Install the 3 clamps with the 3 bolts.
5. FILL ATF AND CHECK FLUID LEVEL