Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
HINT: Install the moulding, aligning the center of moulding with the center of body.
e. Remove any excessive adhesive agent before it hardens.
f.
Hold the glass and moulding in place securely with a protective tape or equivalent until the adhesive hardens.
NOTE: Take care not to drive the vehicle during the time described in the table.
12. INSTALL WINDSHIELD OUTSIDE MOULDINGS
13. INSPECT FOR LEAK AND REPAIR
NOTE: Contact a leak test after the hardening time has elapsed.
14. INSTALL ROOF SIDE RAIL WEATHERSTRIP
Attach the upper edge of the weatherstrip to body flange. Tap on the weatherstrip by hand.
15. INSTALL COWL TOP VENTILATOR LOUVER
16. INSTALL WIPER ARMS
a. Operate the wipers once and turn the wiper switch OFF.
b. Install the wiper arms and tighten the nuts by hand.
c. Adjust the installation positions of the wiper arms to positions shown in the illustration.
A: Approx. 25.4 mm (1.000 in.)
B: Approx. 40.0 mm (1.574 in.)
HINT: When installing the wiper arms, make sure that the tips of the blades are not beyond the ceramic edge as indicated "C" part in the
illustration.
d. Torque the 2 nuts.
Torque: 20 N.m (205 kgf. cm, 15 ft.lbf)
e. Install the 2 cap.
17. INSTALL INNER REAR VIEW MIRROR