Sienna AWD V6-3.3L (3MZ-FE) (2004)
4.
Peel the backing off the center portion (long section).
Push down on the center portion of the weatherstrip to adhere the tape sections to the body.
5.
Use the 3M(TM) Rubber Hand Roller to make sure the weatherstrip is properly adhered to the body. Roll the roller back and forth on the surface
of the weatherstrip applying approximately 11 lbs. of force to the roller and seal
NOTE
Be careful not to wrinkle the rubber as you are applying downward force to the weatherstrip while moving the roller back and forth.