Sienna AWD V6-3.3L (3MZ-FE) (2004)
d. Install the 2 bolts to the brake pedal bracket No.3.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
e. Install the stop lamp switch harness clamp to the brake pedal support sub-assy.
f.
Connect the stop lamp switch connector.
23. FULLY TIGHTEN BRAKE PEDAL SHAFT
a. fully tighten the 2 brake pedal shafts.
Torque: 34 Nm (350 kgf-cm, 25 ft. lbs.)
24. INSTALL INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSY NO.1
a. Install the instrument panel safety pad insert sub-assy No.1 with the 4 bolts.
25. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSY LOWER LH
a. Install the instrument panel finish panel sub-assy lower LH with the 2 bolts.
26. INSTALL COWL SIDE TRIM BOARD LH
27. INSTALL FRONT DOOR SCUFF PLATE LH
28. INSPECT BRAKE PEDAL HEIGHT
29. CHECK PEDAL FREE PLAY
30. CHECK PEDAL RESERVE DISTANCE