Sienna AWD V6-3.3L (3MZ-FE) (2004)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Actuator Assembly (W/ VSC)
BRAKE ACTUATOR ASSY (W/ VSC)
REPLACEMENT
1. DRAIN BRAKE FLUID
NOTICE: Wash the brake fluid off immediately if it attaches to any painted surface.
2. REMOVE AIR CLEANER ASSEMBLY WITH HOSE
3. REMOVE BRAKE ACTUATOR WITH BRACKET
a. Release the latch of the brake actuator connector to disconnect the connector.
b. Using SST, disconnect the brake tubes from the brake actuator.
SST 09023-00100
c. Use tags or make a memo to identify the place to reconnect.
d. Remove the 3 bolts and brake actuator assy.
4. REMOVE BRAKE ACTUATOR ASSY
a. Remove the 2 nuts and brake actuator assy from the brake actuator bracket.
5. INSTALL BRAKE ACTUATOR ASSY
a. Install the brake actuator assy with the 2 nuts to the brake actuator bracket.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)