Sienna AWD V6-3.3L (3MZ-FE) (2004)
Alignment: Service and Repair
Front Wheel Alignment
NOTICE: For Zero Point Calibration information, please refer to: TSB T-SB-0020-8 (3/25/08).
FRONT WHEEL ALIGNMENT
ADJUSTMENT
1. INSPECT TIRE
2. MEASURE VEHICLE HEIGHT
Vehicle height:
FF
4WD
Measuring points:
A: Ground clearance of front wheel center
B: Ground clearance of lower suspension arm No.2 set bolt center
C: Ground clearance of rear axle carrier bush set bolt center
D: Ground clearance of rear wheel center
NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
If the vehicle height is not the specified value, Adjust it by pushing down or lifting the body.