Sienna AWD V6-3.3L (3MZ-FE) (2004)
31.
Release the clip from the middle of the lines.
32.
Remove suction pipe A and liquid pipe C.
33.
Remove the 3 retainer nuts from the rear heater lines.
34.
Lower the rear coolant lines.
35.
Remove suction pipe B and liquid pipe B.
36.
To clean the line, use high pressure shop air to blow through the lines until NO debris is present.
NOTE:
^
Prior to blowing shop air through the A/C lines, let the lines vent for approximately 10 minutes.
^
If solvents are used as a cleaning agent, use only the solvents designed for A/C system cleaning.
37.
Reassemble the rear HVAC in reverse order.
38.
Install the new magnetic clutch assembly, only if damaged.
NOTE:
If NOT damaged, install the magnetic clutch from the original compressor.
A.
Fit the part as shown in the illustration and install the magnetic clutch stator.
B.
Using a snap ring expander, install a new snap ring with the chamfered side facing up.
C.
Install the screw and connect the connector.