Sienna AWD V6-3.3L (3MZ-FE) (2004)
A.
Remove the Circuit Opening Relay from the Engine Room Junction Block in the Engine Room Compartment Left (driver's side).
B.
Start the engine. After the engine has stalled, turn the ignition switch OFF.
C.
Reinstall the Circuit Opening Relay.
D.
Disconnect the negative (-) battery cable.
2.
Disconnect Fuel Pipe Sub-assembly No.1.
NOTE:
^
Ensure that the removed bolt and washers are discarded.
^
Refer to the "Component Identification" section to ensure that the correct bolt and washers are removed and damper is installed.