toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

All Technical Service Bulletins: > < Engine - MIL ON/DTC's P0171/P0174 Set|Page 4262
Page 3
background image

2.

Spray carburetor cleaner near the Intake Air Control Valve pivot shaft and monitor Short Term Fuel Trim as indicated in step 1.

3.

Was the short term fuel trim changing to a rich reading, or negative fuel trim in step 2?

If Yes - Replace the Intake Air Control Valve. Refer to the Technical Information System (TIS), 2004 model year applicable model Repair
Manual: Intake: Intake Air Control Valve Assy No. 2 (3MZ-FE): Replacement.

After the Intake Air Control Valve has been replaced, proceed to step 4.

If NO - Check for other vacuum leaks or lean running conditions per Technical Information System (TIS), 2004 model year applicable model
Repair Manual: Diagnostics: SFI System (3MZ-FE): P0171, P0172, P0174, P0175 System Too Lean.

4.

Is the short term fuel trim now in the negative percent? Is the long term fuel trim returning closer to 0%?

If Yes - Clear short and long term fuel trims by disconnecting the negative battery cable for 90 seconds. Reconnect the negative battery cable and
test drive the vehicle.

After the test drive, proceed to step 5.

If NO - Continue diagnosis for lean running conditions per TIS, 2004 model year applicable model Repair Manual: Diagnostics: SFI System
(3MZ-FE): P0171, P0172, P0174, P0175 System Too Lean.

5.

Confirm lean running condition has been eliminated (short term and long term fuel trims on All Data List are less than +/- 3% on both banks).

All Technical Service Bulletins: > < Engine - MIL ON/DTC's P0171/P0174 Set|Page 4262