toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Engine Controls - MIL ON/DTCs P0037/P0038/P0136|Page 1145 > < Engine Controls - MIL ON/DTCs P0037/P0038/P0136
Page 2
background image

first, from the vehicle's in-service date.

-

For California specification vehicles registered and operated in California, Maine, Massachusetts, or Vermont, this repair is covered under the
California Emission Warranty, which is 36 months or 50,000 miles, whichever occurs first, from the vehicle's in-service date.

-

Warranty application is limited to correction of a problem based upon a customer's specific complaint.

Parts Information

Required Tools & Equipment

NOTE:  

Additional TIS Techstream units may be ordered by calling Approved Dealer Equipment (ADE).

Repair Procedure

1. Disconnect Bank 1 Sensor 2 heated oxygen sensor connector H14.

2. Using a Digital Volt Ohm Meter (DVOM), measure the resistance between the terminals of the heated oxygen sensor connector.

3. If an open circuit is observed in the wiring harness for the oxygen sensor between terminals 1 - 2, replace the sensor.

NOTE:  

Make sure to check for intermittent open circuits in the oxygen sensor wiring harness by moving the oxygen sensor wiring harness while
checking the resistance values.

4. If NO problem with the oxygen sensor wiring harness is detected, follow Repair Manual diagnostics for the applicable DTC to determine the root

Engine Controls - MIL ON/DTCs P0037/P0038/P0136|Page 1145 > < Engine Controls - MIL ON/DTCs P0037/P0038/P0136