Sienna AWD V6-3.3L (3MZ-FE) (2004)
c. Clean the installation surfaces of the shock absorber and the steering knuckle.
d. Temporarily install the 2 nuts.
e. Adjust the camber by pushing or pulling the lower side of the shock absorber in the direction in which the camber adjustment is required.
f.
Tighten the nuts.
Torque: 210 Nm (2,140 kgf-cm, 155 ft. lbs.)
NOTICE: When installing nut, stop the bolt from rotating and torque the nut.
g. Install the front wheel.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
h. Check the camber.
HINT:
-
Adjust the camber to the center of the specified value as much as possible.
-
Adjusting value for the set bolts is 6' - 30' (0.1° - 0.5°). If the camber is not within the specified value, using the following table, estimate
how much additional camber adjustment will be required, and select the camber adjusting bolt.
NOTICE: Tighten the adjusting bolt with a washer and a new nut.