Sienna AWD V6-3.3L (3MZ-FE) (2004)
a. Disconnect the connector.
6. REMOVE REAR AXLE HUB & BEARING ASSY LH
a. Remove the 4 bolts and hub & bearing assy LH.
7. INSTALL REAR AXLE HUB & BEARING ASSY LH
a. Install the hub & Bearing assy LH with the 4 bolts.
Torque: 56 Nm (571 kgf-cm, 41 ft. lbs.)
8. INSPECT BEARING BACKLASH
9. INSPECT AXLE HUB DEVIATION
10. CONNECT SKID CONTROL SENSOR WIRE
a. Connect the connector.
NOTICE: Do not twist the sensor wire when connecting it.
11. INSTALL REAR DISC (DISC REAR BRAKE TYPE)
12. INSTALL REAR BRAKE DRUM SUB-ASSY (DRUM REAR BRAKE TYPE)
13. INSTALL REAR DISC BRAKE CALIPER ASSY LH (DISC REAR BRAKE TYPE)
a. Install the rear disc brake caliper assy LH with the 2 bolts.
Torque: 88 Nm (900 kgf-cm, 65 ft. lbs.)
14. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
15. CHECK ABS SPEED SENSOR SIGNAL
a. ABS WITH EBD SYSTEM
b. ABS WITH EBD & BA & TRAC & VSC SYSTEM