Sienna AWD V6-3.3L (3MZ-FE) (2004)
/Page-1281002.png)
5. SEPARATE SPEED SENSOR REAR LH
a. Removing the bolt, separate the speed sensor rear LH.
NOTICE:
^
Be careful not to damage the speed sensor.
^
Prevent foreign matter from attaching to the speed sensor.
6. REMOVE REAR DRIVE SHAFT ASSY LH
7. REMOVE REAR AXLE HUB & BEARING ASSY LH
a. Remove the 4 bolts and hub & bearing assy LH.
8. INSTALL REAR AXLE HUB & BEARING ASSY LH
a. Install the hub & bearing assy LH with the 4 bolts.
Torque: 56 Nm (571 kgf-cm, 41 ft. lbs.)
9. INSPECT BEARING BACKLASH
10. INSPECT AXLE HUB DEVIATION
11. INSTALL REAR DRIVE SHAFT ASSY LH
12. INSTALL SPEED SENSOR REAR LH
a. Install the bolt, connect the speed sensor rear LH.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE:
^
Be careful not to damage the speed sensor.
^
Prevent foreign matter from attaching to the speed sensor.
^
Do not twist the sensor wire when installing the sensor.
13. INSTALL REAR DISC
14. INSTALL REAR DISC BRAKE CALIPER ASSY LH
a. Install the rear disc brake caliper assy LH with the 2 bolts.
Torque: 88 Nm (900 kgf-cm, 65 ft. lbs.)
15. INSTALL REAR AXLE SHAFT LH NUT
16. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
17. CHECK ABS SPEED SENSOR SIGNAL
a. ABS WITH EBD & BA & TRAC & VSC SYSTEM
