Sienna AWD V6-3.3L (3MZ-FE) (2004)
Shift Cable: Service and Repair
TRANSMISSION CONTROL CABLE ASSY (ATM)
REPLACEMENT
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE LH
3. REMOVE FRONT DOOR SCUFF PLATE RH
4. REMOVE COWL SIDE TRIM BOARD LH
5. REMOVE COWL SIDE TRIM BOARD RH
6. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSY LOWER LH
7. REMOVE GLOVE COMPARTMENT DOOR STOPPER SUB-ASSY
8. REMOVE GLOVE COMPARTMENT DOOR ASSY
9. REMOVE FLOOR CARPET COVER CENTER LH
10. REMOVE FLOOR CARPET COVER CENTER RH
11. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER NO.1
12. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER NO.2
13. REMOVE SHIFT LEVER KNOB SUB-ASSY
14. REMOVE POSITION INDICATOR HOUSING ASSY
15. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSY CENTER
16. REMOVE TRANSMISSION CONTROL CABLE ASSY
a. Remove the nut from the control shaft lever.
b. Disconnect the transmission control cable assy from the control shaft lever.
c. Remove the clip and disconnect the transmission control cable assy from the control cable bracket.
d. Disconnect the transmission control cable assy from the transmission control cable bracket No.2.