Sienna AWD V6-3.3L (3MZ-FE) (2004)
/Page-962011.png)
5. Using SST, measure the installation angle of the rear propeller shaft (c) and rear differential (D).
SST 09370-50010
No 2 joint scale C - D = -1.6° - (-3. 6°)
If the measured angle is not within the specification, adjust it with the center support bearing adjusting shim.
Center support bearing adjusting shim thickness:
g. Install the transfer dynamic damper.
Torque: 26 Nm (260 kgf-cm, 19 ft. lbs.)
19. INSTALL EXHAUST PIPE ASSY
20. CHECK FOR EXHAUST GAS LEAKS
